|
Posted by Nicolai on July 27, 2008, 7:20 am
If you were Registered and logged in, you could reply and use other advanced thread options
After every boot I have to wait for 10-30 seconds before I can ping the
cisco 85x router and the internet. My port is spanning-tree portfast
enabled.
Any suggestions?
|
 
| |
Posted by News Reader on July 28, 2008, 9:23 am
If you were Registered and logged in, you could reply and use other advanced thread options
Nicolai wrote:
> After every boot I have to wait for 10-30 seconds before I can ping the
> cisco 85x router and the internet. My port is spanning-tree portfast
> enabled.
>
> Any suggestions?
>
>
It takes time to decompress and load the software image.
Connect your host to the console port and watch the boot process.
Best Regards,
News Reader
|
|
Posted by Merv on July 28, 2008, 10:14 am
If you were Registered and logged in, you could reply and use other advanced thread options
> After every boot I have to wait for 10-30 seconds before I can ping the
> cisco 85x router and the internet.
reboot of what - the router or a PC connected to the router ?
|
|
Posted by Nicolai on July 28, 2008, 10:25 am
If you were Registered and logged in, you could reply and use other advanced thread options > It takes time to decompress and load the software image.
Sorry, after my PC boot. Router has been up for weeks
|
|
Posted by Merv on July 28, 2008, 11:42 am
If you were Registered and logged in, you could reply and use other advanced thread options
> Sorry, after my PC boot. Router has been up for weeks
How does the PC acquire it's IP address - is it hard coded or is it
assigned via DHCP by router ?
with PC power on and able to ping Internet site, start a long running
ping on your PC in a command window (ping -t x.x.x.x) , then
disconnect the cable to router, should be loss of ping, reconnect,
note whether ping start again immediately - if it does then portfast
is functioning properly
|
| Similar Threads | Posted | | portfast | September 7, 2006, 5:03 pm |
| portfast bpduguard.. | September 8, 2005, 1:06 am |
| Portfast question | September 12, 2006, 9:12 pm |
| spanning tree portfast | March 9, 2005, 3:27 am |
| bpdu portfast enable | October 23, 2006, 5:54 pm |
| Business VoIP Solutions Using Cisco Gateways, Cisco Call Agent, And Cisco IP Phones | October 2, 2007, 8:02 pm |
| Discussion about segregating bandwidth with Cisco 7513, Cisco 3750 and Cisco 3640 | June 17, 2006, 8:34 am |
| cable-modem->d-link 614+-> cisco 3620->cisco 2501->my workstation setup help | July 25, 2004, 10:57 am |
| good cisco and juniper IPS site for intrusion prevention and cisco switch info | January 5, 2007, 4:59 pm |
| Re: Q: Cisco AP 1131 -- "Unsupported device type" error in Cisco Network Assistant | November 27, 2007, 1:19 pm |
|
|
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map