|
Posted by ABLE_1 on September 27, 2006, 6:21 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Did not know that.................. But the same should apply.
> Harris is now owned by Fluke
> ABLE_1 wrote:
>> You might want to contact Harris. They DO have some very amazing
>> customer
>> service.
>>
>>
>> >I have a harris ts21 butt set (old blue style). I bought new test leads
>> >awhile back and during replacement the speaker wire fell off. I could
>> >not
>> >tell where it was soldered on to so I found a spot that seemed to work
>> >and
>> >went for it. this was not the correct spot. I can hear dial tone, but
>> >if
>> >I am trying to detect for noisy line it does not fair to well. I do not
>> >know anybody with same style of butt set to check where speaker lead
>> >should
>> >be soldered to.
>> >
>> > does anybody know where I should solder my speaker lead to? are there
>> > schematics on the web that i can use?
>> >
>> > thanks
>> > rod
>> >
>
|