|
Posted by headsetadapter.com on May 9, 2008, 6:01 pm
If you were Registered and logged in, you could reply and use other advanced thread options
RSTP has the CONVERGENCE time around 1 second - it's time from topology
change (primary path goes down) to a stable state (previously blocked
redundant link goes into Forwarding mode). To speed up the time from the
port become active to the time it starts forwarding traffic, use "spanning
portfast" (or "spantree portfast" on IOS). There is no way to forward any
port until the router actually load and run all software (time from power
up).
Good luck,
Mike
CCNP, CCDP, CCSP, CCVP, MCSE W2K, MCSE+I, Security+, etc.
CCIE R&S (in progress), CCIE Voice (in progress)
------
Headset Adapters for Cisco IP Phones
www.ciscoheadsetadapter.com
www.headsetadapter.com
>I have read rstp but has some questions about it.
>
> 1. Does people need manually config a Alternate port?
> 2. Same qutsion above about backup port.
> 3. Why someone say RSTP convergence time within 1s?
> from power up stage to stable stage?
> or from topology change to stable stage?
> or just for some special case?
>
> TIA,
> st
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map