|
Posted by Wolfgang S. Rupprecht on June 12, 2004, 3:58 pm
If you were Registered and logged in, you could reply and use other advanced thread options
I just upgraded the firmware of my Budgetone-100 to 1.0.50 and noticed
that it added two new codecs. The problem is the firmware upgrade
didn't notice that I had factory settings for the codecs and didn't
want to trash my codec ordering. I'm now left with these two
unselected:
ilbc
g722 wideband
What ordering are others using to go from best-sounding/most-piggish
to crappiest-sounding/least-piggish? I'm tempted to do this, but for
no other reason that my budgetone started with this ordering and I'm
trying to insert the g722 and ilbc in roughly bandwidth-needed order.
pcmu (g711u)
pcma (g711a)
>>> g722 wideband
g723
g729 (a?, b?)
g726-32 (aka g721)
g728
>>> ilbc
-wolfgang
--
Wolfgang S. Rupprecht http://www.wsrcc.com/wolfgang/
New toy: Voice over ip phone. Sounds much better than an analog phone.
http://www.wsrcc.com/wolfgang/voip.html
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map