|
Posted by Barry OGrady on May 13, 2008, 8:44 am
If you were Registered and logged in, you could reply and use other advanced thread options
>Hi
>
>I need scheme to make cable which is connecting pc with baystack 350
>to set switch up by telnet.
>
>Here is link to manual of my baystack:
>
>http://www25.nortelnetworks.com/library/tpubs/pdf/switches/bstack/350F/04376C00.PDF
>
>on page 245 is scheme how connect pins, but there is only one side...
>
>I thing It should be like I drow it under?
>There is a view of cable with two plugs...
> ___ ___
>/ \ / \
>| \ | \
>| 1 ---------| --- |---- 1 |
>| 6 ----| --- |-------- 6 |
>| 2 ---------| --- |---- 2 |
>| 7 ----| --- |-------- 7 |
>| 3 ---------| --- |---- 3 |
>| 8 ----| --- |-------- 8 |
>| 4 ---------| --- |---- 4 |
>| 9 ----| --- |-------- 9 |
>| 5 ---------| --- |---- 5 |
>| / | /
>\___ / \ ___ /
>
>
>1 CD Carrier detect (not used)
>2 TXD Transmit data (output)
>3 RXD Receive data (input)
>4 DTR Data terminal ready (not used)
>5 GND Signal ground
>6 DSR Data set ready (output always asserted)
>7 RTS Request to send (not used)
>8 CTS Clear to send (output always asserted)
>9 RI Ring indicator (not used)
>Shell Chassis ground
My Baystack 450 is straight through pin for pin as shown.
>thanks for your help...
Barry
=====
Home page
http://members.iinet.net.au/~barry.og
|