|
Posted by on July 13, 2006, 1:38 pm
If you were Registered and logged in, you could reply and use other advanced thread options
hi,
we have 2* 2208 load balancer switches. i would like to know if the
/c/slb/sync/ peer 1 +2 and the update <x> and session sync enable
settings are just for the following
- syncing the slb/vrrp configs with /oper/slb/sync typically from
alteon1 to alteon2
- exchanging the session info for failover reasons
therefore is it best to
- create a seperate port/vlan and put 2 interfaces for each alteon, use
this for the above and join them with a cross cable, peer 1 will have
1st load balancer address, peer2 will have the second.
thx
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map