|
Posted by Tom on June 13, 2007, 8:19 am
If you were Registered and logged in, you could reply and use other advanced thread options
On Wed, 13 Jun 2007 10:37:40 +0100, Kevin Wincott
>Hi
>
>I am getting the following error when installing wic 1Eth on a 2612
>router, its using IOS (tm) C2600 Software (C2600-BIN-M), Version
>12.2(11)T, RELEASE SOFTWARE (fc1) which I believe should support this,
>although I have read many conflicting reports
>
> WIC Slot 1:
> Unknown WAN daughter card
> Hardware Revision : 3.0
> Part Number : 73-5797-03
> Board Revision : A0
> Deviation Number : 0-0
> Fab Version : 02
> PCB Serial Number : f0c09347052
> RMA Test History : 0D
> RMA Number : 0-0-0-0
> RMA History : 00
> Top Assy. Part Number : 800-09311-03
> Connector Type : 01
> Chassis MAC Address : 0004.dc0c.b583
> MAC Address block size : 29559
> EEPROM format version 4
> EEPROM contents (hex):
> 0x00: 04 FF 40 00 39 41 03 00 82 49 16 A5 03 42 41 30
> 0x10: 80 00 00 00 00 02 02 C1 8B 66 30 63 30 39 33 34
> 0x20: 37 30 35 32 03 0D 81 00 00 00 00 04 00 C0 46 03
> 0x30: 20 00 24 5F 03 05 01 C3 06 00 04 DC 0C B5 83 43
> 0x40: 73 77 FF FF FF FF FF FF FF FF FF FF FF FF FF FF
> 0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
> 0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
> 0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
That module is only supported on the 17xx series of routers. To get
more ethernet ports, you'll have to use a NM (Network Module), not a
WIC.
Tom
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map