|
Posted by Mike Drechsler - SPAM PROTECTE on December 1, 2005, 6:55 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Simple_Net_User wrote:
> I hope someone can help me.
>
> Problem:
>
> I use Netgear Prosafe VPN Client, and several D-Link VPN routers at
> different locations. Setting up the tunnels so they work is no problem, and
> I can connect from where ever I am located to all Routers.
>
> But I have problems when I am located inside a local network that use the
> same subnet as I have inside the remote subnet.
>
> Example: Office with VPN Router 192.168.1.x / 255.255.255.0 - Locale subnet
> of Hotel 192.168.1.x / 255.255.255.0
>
> When both remote loacle net and locale net use the same IP range I can
> connect to the VPN tunnel, but I can't reach the computers inside the remote
> net.
>
> Using e.g. D-Link DS-601 VPN Client this works just fine as I can set the
> locale subnet to what ever I want in the VPN Client, but with Netgear
> Prosafe VPN Client I can't figure out how to get past this problem.
>
> Anyone have the solution to this?
>
> Desperatly in need of good advice :-)
Renumber your office to use a less common subnet. Avoid 192.168.0.x and
192.168.1.x. Try for something less common like something in 10.x.x.x
--
WARNING! Email address has been altered for spam resistance.
Please remove the -deletethispart-. section before replying directly.
Mike Drechsler (mike-newsgroup@-deletethispart-.upcraft.com)
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map