|
Posted by np on May 2, 2008, 12:39 pm
If you were Registered and logged in, you could reply and use other advanced thread options
I've been asked to check whether the Telco (BT) has set some ISDN lines
as point-to-point or point-to-multipoint. If I plug a 2503 (or 2621 with
a BRI S/T WIC) into them, is there part of a debug or show isdn command
that would tell me? I know a tester would tell me, but someone's
borrowed ours and is being somewhat coy about its whereabouts. Thanks in
advance.
--
NP
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map