Tool To Diagnose Network Configuration Errors

Tool To Diagnose Network Configuration Errors

NewsGroups | Search | Tools
 comp.dcom.lans.ethernet  Post an article  get this group's latest topics as an RSS feed add this group's latest topics to your My MSN content add this group's latest topics to your My Yahoo content  add this group's latest topics to your Google content  YahooMyWeb Yahoo!  Google Google  Windows Live Favorites Windows Live  del.icio.us del.icio.us  digg digg  Add to Netscape Netscape
Subject Author Date
Tool To Diagnose Network Configuration Errors Will 11-19-2006
Posted by Will on November 19, 2006, 12:22 am
If you were  Registered and logged in, you could reply and use other advanced thread options


Does any vendor make a network configuration diagnostic tool that would let
you run the application at two endpoints, pass data between the two copies
of of the application, then diagnose problems with the network settings at
either end point? For example, such an application might notice that you
have jumbo frames enabled on gigE, but that the TCP Window size is set for a
number that is smaller than your jumbo frames (thereby undoing the value of
the jumbo frames). The application might notice that you have jumbo
frames enabled correctly at the sending side, but that the receiver is
getting fragmented packets, indicating that something between the two points
is fragmenting them.

Basically I am looking for a tool that will look at things like MTU, MSS,
window sizes, unexpected latency, etc and then help to deduce and explain
specific network configuration errors or topology problems. It is an
extreme drag to have to diagnose problems with things like MTU, MSS, jumbo
frames, manually, through knowledge, using of pings, network sniffers, etc.
I have to believe that a lot of this could be automated by an appropriately
smart diagnostic application.

--
Will



Similar ThreadsPosted
Network configuration problem September 7, 2007, 7:23 am
Soft Ethernet BER Tester Tool August 20, 2006, 4:09 am
LAN Configuration January 6, 2006, 11:37 am
VLAN Configuration October 20, 2005, 8:26 pm
Supply RJ45 Crimping Tools(Punch Down Tool) November 1, 2005, 8:10 pm
Cat6 tool-less jacks for pair-bonded cable? January 28, 2006, 12:27 am
Is explicit switch configuration for dynamic lacp required????? December 22, 2005, 11:52 am
VNSwitch 900CG Installation and Configuration Manual? (DECHub/MultiSwitch 900) September 23, 2008, 10:05 pm
CRC Errors on GigE. December 10, 2006, 3:28 am
"TCP segment of a reassembled PDU" Errors August 10, 2007, 4:38 pm

other useful resources:
The Federal Communications Commission (FCC)
Telecommunications Industry Association
Electronic and Software Security Products and Services
International Telecommunication Union

Custom CGI Perl and PHP programming by 1-Script.com

Contact Us | Privacy Policy
The site map in XML format XML site map