|
Posted by on September 11, 2006, 9:50 pm
If you were Registered and logged in, you could reply and use other advanced thread options
I am attempting to add a menu point to my first level. After I add the
menu point prompt, I can't figure out how to add options(paths) to that
menu. For example, if I choose path 5 on level 1 to be a menu prompt,
it allows me to enter the voice prompt for the menu, but then I can't
figure out how to add a path 1, 2 etc to this new level. The system
says I can add 8 paths to each level ( 73 total menu points ) .
The problem is, I can't figure out how to access the new level created
by this menu prompt! If enter path 1, it has me editting the path 1 of
Level 1.
If I don't add paths to my menu prompts, then I get "incomplete tree"
when I try to enable this tree. So, I know it recognizes that as a
menu!
Any help out there?
|
|
Posted by on September 12, 2006, 10:00 am
If you were Registered and logged in, you could reply and use other advanced thread options
I FOUND THE ANSWER!
After you add a menu point, you use a 2 digit path to refer to the
option points under that menu. (You cannot add a menu point to a second
level menu - don't even try it!).
For example, if I make path 2 a menu point, then path 21 refers to menu
2, option 1, 22 refers to menu 2 option 2, etc.
I found this by mistake when I typed two digits one time and it did not
give me an invalid path message. Suddenly I realized the process!
|
| Similar Threads | Posted | | Startalk Second Level Menu Option | April 30, 2006, 9:12 am |
| Adding T1 | February 6, 2005, 9:09 am |
| Adding new DN key | September 27, 2006, 12:01 pm |
| Adding a new cascaded switch | March 23, 2007, 2:28 pm |
| Adding caller ID to DID lines in MICS 1.1 | August 16, 2006, 4:01 pm |
| steps on adding a new agent on a nortel | August 29, 2006, 9:54 am |
| adding a m7310 to a small norstar system | April 27, 2005, 10:17 am |
| Removing/Adding an extension to Nortel IP Phone 2002 | April 21, 2008, 3:59 pm |
| MICS 4.0 - Adding or initializing a POTS line into a loop trunk. | August 11, 2005, 2:21 pm |
| Moving extensions and adding extensions | August 24, 2006, 2:30 pm |
|
|