|
Posted by Henry Cabot Henhouse III on September 18, 2006, 3:51 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Perhaps someone with a little Mitel under their belt can tell me if this is
possible:
I have a 200 (19.3) connected by a T1/D4 tie line to a 2000 (29 q40). The
2000 has PRI.
Outside calls on the 200 get routed over the tie line, and out the PRI on
the 2000. The outbound CPN shows the default.
Is it possible to send the station id with the call to the 2000 so it can
outgoing caller id can be sent with the proper number?
Thanks in advance!
Dave
|