|
Posted by Henry Cabot Henhouse III on July 3, 2006, 6:13 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Hi...
The main site SX2000 (lw29 q40) location has 2 pris, the SX200 (lw 19.3)
remote location has 1. The two switches are connected by a T1 tie line. One
of the pris at the main site is flat rate. I can send local calls from the
200 over the tie line, but the outbound caller ID shows the default CPN
number.
Will AAN allow me to send the callers extension number from the 200 to the
2000 which in turn would be sent out correctly on the pri? Or, is there a
better way to accomplish this?
Thanks in advance
Dave
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map