|
Posted by JanBN on February 10, 2007, 11:45 am
If you were Registered and logged in, you could reply and use other advanced thread options wrote:
>
>
>
>
>
> > On Feb 5, 5:08 am, "flamer die.s...@hotmail.com"
>
>
> > > > Hi All
>
> > > > I have enabled SNTP on our switches. Maybe it is me who is confused
> > > > about the concept (Even though it is supposed to be simple:)), but =
it
> > > > shows the time an hour off.
>
> > > > I have tried to find a command that can change the time zone, but c=
ant
> > > > seem to find one.
>
> > > > Can anybody help me get on the right track.
>
> > > > Thanks in advanced.
>
> > > > Jan
>
> > > have you configured summer-time (daylight savings) correcty?
>
> > > Flamer.
>
> > Hi Flamer
>
> > Thank you for your quick answer - i am very sure that you right, that
> > must be it.
>
> > I have tried to find a command to change it, but i cant seem to. Do
> > you know how i can change it?
>
> > Best regards,
>
> > Jan
>
> from the documentation:
>
> clock summer-time
> The clock summer-time command sets the daylight savings time with
> start
> and end dates. The syntax for the clock summer-time command is:
> clock summer-time <zone> [date {<day> <month> <year>
> <hh:mm>} {<day> <month> <year> <hh:mm>}] [<offset>]
>
> The whole document is here:http://www130.nortelnetworks.com/go/
> main.jsp?cscat=3DDOCDETAIL&DocumentOID=3D367669&RenditionID=3D
>
> Should be the same for all models, do it through the command line
> configure mode.
>
> Flamer.- Skjul tekst i anf=F8rselstegn -
>
> - Vis tekst i anf=F8rselstegn -
Hi Framer
This command does not seem to excist on a Nortel ERS 5520 switch.
Best regards,
Jan
|