|
Posted by on August 18, 2006, 4:37 pm
If you were Registered and logged in, you could reply and use other advanced thread options
dadoo3002@gmail.com wrote:
> Does anyone out there know how to set up the roving analysis port on a
> 3com 4400? There's no mention of it on the web interface. If I Telnet
> in, go to "feature/rovingAnalysis", and use the "add" command, I get
> "No ports are available to be used for Roving Analysis."
>
> I tried removing the desired port from its VLAN, enabling/disabling it,
> etc., all with no effect.
I have no experience of this hardware:-
Google says:
[Roving analysis port on 3com]
Have you enabled Roving Analysys globally?
> How to create monitoring port (Sniffer Port) on 3Com switch 3300XM?
> Thanks
http://groups.google.co.uk/group/comp.dcom.lans.ethernet/browse_frm/thread/762e3654f832f3cc/f4a2881ad12a2b9c?lnk=gst&q=Roving+analysis+port+on+3com&rnum=3#f4a2881ad12a2b9c
Do you have fairly current firmware in that switch? The latest is
2.72,
released Sept. 2004. Monitoring may not be available in older
firmwares
(mine has 2.71).
In the web GUI, click Configuration on the left-hand side, then click
"Roving Analysis Port." Then change "Roving Analysis State" to
"Enabled," and select a port to monitor (looks like you can only
monitor
one at a time) and a port to mirror it to (analysis port). If you have
a stack you should be able to have a monitor port and analysis port in
different units.
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map