|
Posted by Trendkill on June 29, 2007, 7:13 am
If you were Registered and logged in, you could reply and use other advanced thread options
> Hi all,
>
> I have a few Cisco 2960 24 and 48 port switches plus a couple of Cisco
> 3560 24 port switches. As part of our repair procedure for cold swap
> we are looking at swapping over the flash memory from the potential
> faulty box to the new box in order for quick config load. However, I
> cannot seem to find any documentation about changing the flash memory
> on these switches. Are they soldered in or are they removable?
>
> Thanks in advance,
>
> Chris
I'm not even finding an internal diagram of the devices. I would
guess this is not supported and may void a warranty, but depends if
you care about that or not (depends where/how you got the spares I
suppose). No clue if its soldered or not, probably have to open one
up and find it.
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map