|
Posted by Carl Navarro on July 27, 2006, 12:16 am
If you were Registered and logged in, you could reply and use other advanced thread options
On Wed, 26 Jul 2006 15:55:18 GMT, user@host.com (Cheech Chong) wrote:
> Hello all,
> Recently setup a used phone system for our office (NT5801FD-93) with
> M7310 phones. The KSU supports up to 6 lines, but we only have 2
> lines at the moment.
> The caller id does not display on the M7310 phones, but prior to
> having a phone system, the regular household phones we had connected
> to our 2 lines were able to display the caller id.
> Is there some programming needed in the phone system to allow the
> caller id to display? I logged into the KSU and didn't see any caller
> id options, but I could have missed the section. (The phone system has
> the following software installed: SP 30NSE08 DR5)
It's as you suspect, in need of programming. Take the box off the
wall and replace it with a CICS 7.0 with CID trunks and you're good to
go.
A 4x16 CICS will run about $1k.
Carl Navarro
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map