|
Posted by Fred Marshall on November 20, 2007, 10:49 am
If you were Registered and logged in, you could reply and use other advanced thread options
I have a working RV042/RV042 wite-to-site VPN.
I need to replace one end with an SSG-5.
I've not set up an SSG-5 before but it seems more or less "OK" and will be
better as soon as I really figure out what "objects" and "addresses" and
"policies" are....
But, following canned instructions and with some help from tech support I've
been able to get the SSG-5 set up. Yet, no connection. I don't see the VPN
/ tunnel listed in the Interface link status: ... should I? Seems like.
Wouldn't know where else to look. (The RV042 reports the VPN status on the
VPN summary page - and it's not connected).
I have this all set up in a lab with a router simulating the internet
connections (both public IPs are on the same public subnet)- so it's easy to
try things at both "ends".
Any help / advice would be appreciated.
Fred
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map