|
Posted by Mac on April 25, 2005, 5:45 pm
If you were Registered and logged in, you could reply and use other advanced thread options
>Mac wrote:
>>
>>
>>>I have a Intel PRO/100 VE Either card my settings show a Tcp Receive
>>>Window of 16060 and a MTU of 1500 on my Dr. TCP WinXP. I'm trying to
>>>find a better value to try but I'm not sure were to start. This set up
>>>runs around 2150 kbps but has a terrible hesitation before it starts.
>>
>>
>> Try running the Tweak Test at this site: http://www.dslreports.com/tweaks
>> Then see what it says under Notes and recommendations: at the bottom of
>> the first column. My results look like this:
>>
>> 1. Your Tweakable Settings:
>> Receive Window (RWIN): 64240
>> Window Scaling: 0
>> Path MTU Discovery: ON
>> RFC1323 Window Scaling: ON
>> RFC1323 Time Stamping: OFF
>> Selective Acks: ON
>> MSS requested: 1460
>> TTL:
>> (less any hops behind firewall)
>> 65
>> TTL remaining: 51
>>
>> Notes and recommendations:
>> RWIN is in range
>> Looking good
>>
>> Mac
>Do you think my RWIN of 16060 is too low?
>My results are:
>Receive Window (RWIN): 16060
>Window Scaling: off
>Path MTU Discovery: ON
>RFC1323 Window Scaling: OFF
>RFC1323 Time Stamping: OFF
>Selective Acks: ON
>MSS requested: 1460
>TTL: unknown
>TTL remaining: 116
That figure does sound too low to me. What did it say under
Notes and recommendations: ? I think that a RWIN of 64240
might be a good one for you.
Mac
|