|
Posted by on October 4, 2006, 3:17 am
If you were Registered and logged in, you could reply and use other advanced thread options
Hi, We have a passport 7480 running 7.2, and just want to configure
static route ecmp with Cisco 2600, via E1 interface. From traffic
monitor, we can see packets being sent from Cisco are shared. (We use
per packet sharing). However, packets sent from Nortel always goes via
one route.
There are two routes from 7480 to Cisco with same metric. We have set
maxEcmpNextHops on nortel virtual router to 3, and we checked
"protected static routeentrys" is disabled. Still not working.
Any ideas?
Thank you in advance.
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map