|
Posted by TouchToneTommy on May 21, 2007, 1:34 am
If you were Registered and logged in, you could reply and use other advanced thread options
>Anyone know the DTMF specs for various Partner phone system
>functions? I'm trying to simulate the "Recall" feature (F03) using a
>Dialogic D4/PCI card. Actually that's all I need. I need to send a
>hookflash to the CO line from a PC based IVR system.
>
>Actually I may be way off base here - I'm assuming the phones use DTMF
>or some type of tones to tell the processor what to do when a feature
>button on the hand set is pressed, but I don't actually have a partner
>phone to test that theory.
>
>
>Dave
# on a single line phone is equivelant to Feature on a system phone.
But you will need to be on Intercom to do it. So, assuming that you
are on a CO line with an incoming call, and you need to flash the CO
line to initiate a CO transfer, you would flash, which puts your
caller on system hold, brings you to Intercom dial tone, dial #03 for
CO flash, pause, then dial the outgoing number, pause again, then
disconnect.
Good luck!!
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map