|
Posted by T on April 28, 2006, 9:20 pm
If you were Registered and logged in, you could reply and use other advanced thread options
We are using PP 15K on source spvc and spvp on two originating ports.
Uni 3.1 OC12 loop --PP15K----OC48---(transit
node)---OC48---PP15K----OC12 Uni 3.1 loop
SPVC originating (5K calls)
(5K calls) terminating SPVC
When we port lock on originating side we see alot of call releases to
the transit node but we clear the call on transit node but we don't get
the call cleared acknowledgement back from the originating side and
therefore we timeout and run in to a problem whereby transit node takes
over a few minutes to clear all the calls (over 9 or 10 minutes).
If we pull the cable on terminating node, we do not see the same
problem.
Can anyone make a comment on what might be causing or any suggestions
on this ?
Also, we are looking for information about how to determine or find
default or see if nortel uni port has sscop default value.
T
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map