|
Posted by Rich Piehl on February 20, 2008, 11:37 pm
If you were Registered and logged in, you could reply and use other advanced thread options
> Recently our local CO installed a new switch. Now we are having
> problems with our Mitel SX-200
> ground start lines. Seems the SX-200 doesnt hold the ground start long
> enough for the new CO to
> recognize a call for dial tone. The SX-200 will pull a dial tone
> about 30 percent of the time. I dont
> see that the ground start timing is variable on the Mitel SX-200. I
> hope the CO can make some
> sort of accomodation. Anybody run into this kind of a problem on some
> of the newer CO switches
> they are installing around the country Id appreciate hearing what you
> were able to do about it.
> Bry
Asking the obvious (because I've seen it before) are you sure when they
replaced the switch all your ground start lines are still ground start
and loop start lines for extraneous devices are still loop start. I've
seen the telcos or clec bolix it up on those kinds of switches on more
than one occasion.
Take care,
Rich
God bless the USA
--
That's one of the problems in this country
The nuts don't know they're nuts.
--Jeff Foxworthy
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map