|
Posted by Bob on June 29, 2006, 10:46 pm
If you were Registered and logged in, you could reply and use other advanced thread options
> On Wed 28 Jun 2006 02:43:49p, adepaolis@gmail.com, wrote:
>
>> Is it possible to change the number of rings a 500 set rings before
>> hunting to voice mail? Right now when I call ext 7827, it will ring
>> 5 or 6 times, I want to make it so that it rings only 2 times and
>> then hunts. I dont want to change all phone sets, just this specific
>> one. We have an older Meridian SL1 pbx.
>
> Yes.
>
Maybe, actually. That's why I asked what release he was on.... If he's on a
release 5 SL-1 MS with a tape drive (He did say "older Meridian SL1", so the
possibilities are endless) he'll be kinda out of luck. I did see in a later
post that he's got a LAPW problem, so he's gotta be 22 or newer.......
> You use the RCO prompt. It's normally set to 0 (the default) but it can
> be set to 1 or 2 also. You define the number of rings in Load 15
> (Customer Data Block). Look under RDR (Call Redirection), there you
> will find CFN0, CFN1 and CFN2. These are normally set to 4 (rings) but
> can be set to anything between 1 and 15. CFN0 applies to RCO 0, CFN1 to
> RC0 1, and CFN2 to RC0 2.
>
> Good luck.
>
> --
> RonB
> "There's a story there...somewhere"
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map