|
Posted by RC on November 17, 2006, 4:58 pm
If you were Registered and logged in, you could reply and use other advanced thread options
calls through the CO, so that they are no longer on the customer's PRI. This
is part of the ISDN standard (both BRI and PRI) but it must be enabled at
the CO (that easy), and supported by the phone system, which it is not on
the MICS.
Either do it as an off-premises forward, which will use 2 channels for each
active forwarded call. Or get a better system.
> With Pri it is pretty simple you have to build a routing table to dial out
> over the PRI then assign your DID target line of the main number to a set
> and the you can use Feature 4 to forward out.
>
> John 807
>> In a couple of weeks I will be adding a PRI, have experience with DID but
>> not this.My main problem is, how to call forward incoming calls to an
>> outside answering service ? Would appreciate any help
>>
>> TerryS
>>
>
>
--
Posted via a free Usenet account from http://www.teranews.com
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map