|
Posted by Jason on February 27, 2008, 2:44 pm
If you were Registered and logged in, you could reply and use other advanced thread options
> You may have found the reset procedure but if you don't know the cause
> you might get locked out again.
>
> Enabling "aaa new-model"
>
> Will automatically start asking for username and password.
> If none is configured and no authentication method is configured then
> you will get locked out.
>
>
> On 2/25/08 3:32 PM, in article
> Xns9A4FD0E9FD311SpamSpamSpamSpanishI@140.99.99.130, "Jason"
>
>>
>>> Due to the problem I had on my switches (2950s) recently I decided
>>> to wipe them both & start afresh, this worked fine with SWITCH1, but
>>> unfortunately after initially configuring SWITCH2 I somehow have
>>> locked myself out of both the console login & the vty login. At both
>>> prompts I am asked for a username, but whatever I type in I get the
>>> message:
>>>
>>> % Login invalid
>>>
>>> I am sure I set everything up as previously, but even allowing for
>>> spelling mistakes and capitals I have tried every possible
>>> combination to no avail. Could I have set up to prompt for a
>>> username & not set one? Either way, does anyone know how I can reset
>>> the switch without access to exec mode?
>>>
>>> Any suggestions greatly received, TIA, Jason
>>
>> Apologies, I found the reset procedure on Cisco's web site.
>
Thanks Yandy.
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map