|
Posted by Nazule on October 3, 2006, 12:26 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Tia,
Line appearance and ringing are set in the configuration mode of the
Norstar system programming. This is generally accessed by Feature**
config config 236344
But your password may be different and you may access it using admin
config depending on the age of your system and model etc etc.
You choose the set DN you want to change the line appearance on and
adjust to appear and ring. 01, 02, 03 or whatever your trunk numbering
is. I'm assuming two digit numbering based on the number of lines you
have.
If you need more assistance provide the exact model of Norstar you are
using. IE. MICS 4.0 CICS 2.0 8x24 6x16 etc.
Brett
Louigee wrote:
> Hi All!
>
> This is probably a very easy question. Tho it has us stumped here.
> About a year ago, we setup our phones so that 3 of the 7 phones will
> ring.
> We currently have 3 lines that the main line will roll over and into if
> the 1st line is busy.
> Anyone answering 1 of the 3 phones will automatically pickup the line
> that is calling upon lifting the receiver.
> How do you set this up on in the programming section of the Norstar
> system?
> We need to have a 4th phone ringing when a call comes in.
>
> We use M7310 as the main phone, and M7208 handsets everywhere else.
>
> Tia
> Louigee
|