|
Posted by Wintensive on February 9, 2006, 2:21 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Hello everyone. I haven't been able to find a solution to my vpn tunnel
problem.
I have 1 RV042 at each end point. one runs on a static IP the other one
uses DDNS. I setup a dedicated VPN tunnel between the two locations and
can get it to connect. The problem is that the tunnel will disconnect
after several minutes. If you choose the Keep Alive option it will
reconnect, however the disconnection causes my file transfer/backup
routine to fail. The error I get from my Smartsync software is
"Network is no longer available." and the sync fails. I have heard
this is due to MTU setting so I changed it on both routers (not my NIC)
down to 1340. Still no luck.
I can connect to each router as a vpn client using quickvpn with
relatively no problems thus far, except that connecting to the one with
DDNS sometimes results in a disconnection if I leave it idle for any
period of time.
What should I try to do? Thanks in advance for the help!
| 
NewsGroups 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map