|
Posted by Bill on September 9, 2007, 8:08 pm
If you were Registered and logged in, you could reply and use other advanced thread options
> Hi all, i have to setup some specific dialout setup only with ISDN
> PRI. I need to dial my one PRI on DTMF (Digit by digit) rather sending
> out whole number as message, Can somebody did that ? or guide me how
> to do that?
> PBX is Nortel CS1000, Rls 4.00 with 2 PRI`s.
Then it's not a PRI. There are applications where DTMF is sent after a call
is set up using the D-Channel - individual user id's, or through dialing on
a menu - but the destination address of the call is ALWAYS set up via out of
band signaling - D-Channel - on a PRI. If you want to set the call up with
DTMF and A-B signaling, you need to program the DTI as non-ISDN.
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map