|
Posted by f/fgeorge on September 10, 2006, 2:10 pm
On 10 Sep 2006 10:31:56 -0700, anthony.oren@gmail.com wrote:
>DD-WRT Will not display LAN/WAN IP just 0.0.0.0 for everything!
>
>Ok I have a huge problem and I hope this doesn't mean my router got
>bricked.
>Following the instructions at
>http://thescorpion420.dyndns.org/portal/content/view/27/36/,
>I skipped the first two steps referring to using
>vxworks_killer_g_v06.zip and the VXWorks Killer image tool to create an
>image of my WRT54G MAC adress. I screwed up the first step and was
>unable to get "Management Mode Firmware Upgrade Screen".
>
>So I just used tftp.exe to Upload an image of
>dd-wrt.v23_micro_generic.bin. Now I log into http://192.168.1.1 and see
>the DD-WRT Control Panel but it won't read my LAN/WAN IP. If I go to
>status it just says:
>
>Login TypeAutomatic Configuration - DHCP
>Login Status
>IP Address0.0.0.0
>Subnet Mask0.0.0.0
>Gateway0.0.0.0
>DNS 1 DNS 2 DNS 3
>Remaining Lease Time0 days 00:00:00
>
>Also since I didn't do the MAC ADDRESS imaging thing, the MAC Address
>of my router is the DD-WRT default: 00:40:10:10:00:02 . Is there anyway
>to fully start over and go back to the original Linksys control panel
>or atleast to fix the DD-WRT configurations?
>
>I would appreciate any help at all. Thank you in advance!
Unplug the router and go the LinkSys site and download the latest
version of the software for your router. Then reconnect the router and
go thru the process again except this time point it to the LinkSys
software instead of the aftermarket stuff. Next time LEAVE IT ALONE,
there is not a of tweaking you get anyway! And what tweaking you do
get does not extend the range!!!!
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map