|
Posted by panky on May 27, 2006, 4:02 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Hi All,
I need an urgent help, hope you guys will help as you have been doing
the past.
I need to configure the DASS2 for my PBX in Uk. This is my first
experience with UK ISDN. i have been doing the same with US PSTN a lot
of times.
I am using NTBK50AA card with the D-channel daughter board on it.
Following is the PBX config
ADAN DPNSS DCH 9
CTYP MSDL
CARD 31
PORT 1
DES DSG
USR DPNSS
REQ prt
TYPE ddsl
DDSL 9
DDSL 9
S2 1
SIGL DA
DDCS 31
PRIV N0
SIDE BNT
L2_RST YES
I am not able to enable the DDSL in Ld 75. It gives me following error:
DTM304 9 0and the card LED shows OOS LED as RED. I am able to Enable
the MSDL in LD 96 and the S1 is set in DPNSS mode.
Any help is appreciated, i need to make the circuits up soon and will
help your help.
Thx in advance. You guys have always been the great help.
.
Regards
PA
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map