|
Posted by Tintin on August 1, 2007, 1:31 am
If you were Registered and logged in, you could reply and use other advanced thread options
Hi Sir,
I realize that this topic has been discussed before but I am literally
upto the wall with my attempts. I am turning to the forum after my
futile attempts to connect my PowerBook G4 to a 2521 Cisco routers
Console port.
My setup is as below:
PB <--> USB port <--> USB to Serial Cable <--> Serial-to-DB9 adapter
<--> Rollover cable <--> Console port
My connection settings are:
9600 baud
8 data bits
No Parity
1 Stop bit
No flow control
Symptoms after this connection:
The ZTerm screen stays absolutely blank.
Please help!!
Thank you for your time.
- Tintin
|