|
Posted by saintjmf on June 20, 2008, 9:50 pm
If you were Registered and logged in, you could reply and use other advanced thread options
I installed the NM and the VIC but do not get anything when I try and
conifgure the voice ports.
oip-rtr(config)#voice-port
^
% Invalid input detected at '^' marker.
voip-rtr(config)#
---------------------
Here is my IOS and sh run and ver -- no voice ports showing up:
isco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-IS-M), Version 12.3(3i), RELEASE
SOFTWARE (fc1)
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Fri 12-Aug-05 13:36 by ssearch
Image text-base: 0x80008098, data-base: 0x819EA9AC
ROM: System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE
(fc1)
voip-rtr uptime is 30 minutes
System returned to ROM by power-on
System image file is "flash:c2600-is-mz.123-3i.bin"
cisco 2610XM (MPC860P) processor (revision 0x300) with 94208K/4096K
bytes of mem
ory.
Processor board ID JAE08127Q3B (406705196)
M860 processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
1 FastEthernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
2 Voice FXO interface(s)
32K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
voip-rtr#sh voice dsp
DSP DSP DSPWARE CURR BOOT
PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT
PACK COUNT
==== === == ======== ======= ===== ======= === == ========= == =====
===========
=
voip-rtr#
---------------------
Current configuration : 713 bytes
!
version 12.3
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname voip-rtr
!
boot-start-marker
boot system flash c2600-is-mz.123-3i.bin
boot-end-marker
!
logging buffered 4096 debugging
!
no aaa new-model
ip subnet-zero
ip cef
!
!
no ip domain lookup
!
!
!
!
!
!
!
!
!
!
no voice hpi capture buffer
no voice hpi capture destination
!
!
!
!
!
!
interface FastEthernet0/0
ip address dhcp
duplex auto
speed auto
!
!
interface Serial0/0
no ip address
shutdown
no fair-queue
!
interface Serial0/1
no ip address
shutdown
!
ip http server
ip classless
!
!
!
!
!
!
!
!
!
line con 0
line aux 0
line vty 0 4
How do I get these ports to be identified?
THANKS for any help
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map