if I try... the group name and password
I get... "a user attempted to log on using only group credentials"
if I try... a username and password set up internally as shown in the
above link
I get... "User not found" (internal is one of the choices listed in
authentication servers)
if I try... a username set up in Kerberos/AD
I get... "Invalid password" (and I'm positive this username and
password are working with an IPSec connection. IPSec connections
through the Cisco client are what are normally used with this
concentrator)
How can I get PPTP connections to work?
Posted by Phillip Remaker on May 24, 2005, 4:59 am
If you were Registered and logged in, you could reply and use other advanced thread options
Apparently a good reference is
http://my.execpc.com/~keithp/pptp.htm
Posted by Phillip Remaker on May 24, 2005, 5:00 am
If you were Registered and logged in, you could reply and use other advanced thread options
Ooops, sorry, that is IOS instructions.
Why not just use the Cisco VPN client for the 3000 series?