|
Posted by Ali Sonday on June 29, 2006, 10:57 am
If you were Registered and logged in, you could reply and use other advanced thread options
Plse assist if possible, I am getting this message on our VPN
concerntrator and the user therefore can not connect anywhere:
26028 06/29/2006 09:03:19.800 SEV=4 IP/6 RPT=9
Unable to add static route to 192.168.191.129.
How can I resolve this?
See full log below:
26016 06/29/2006 09:03:18.540 SEV=4 IKE/52 RPT=773 152.111.124.186
Group [3rdParty] User [Matador1]
User (Matador1) authenticated.
26017 06/29/2006 09:03:18.670 SEV=5 IKE/184 RPT=771 152.111.124.186
Group [3rdParty] User [Matador1]
Client Type: WinNT
Client Application Version: 4.6.02.0011
26019 06/29/2006 09:03:19.780 SEV=4 AUTH/22 RPT=1019 152.111.124.186
User [Matador1] Group [3rdParty] connected, Session Type: IPSec
26020 06/29/2006 09:03:19.780 SEV=4 IKE/119 RPT=1113 152.111.124.186
Group [3rdParty] User [Matador1]
PHASE 1 COMPLETED
26021 06/29/2006 09:03:19.790 SEV=5 IKE/25 RPT=769 152.111.124.186
Group [3rdParty] User [Matador1]
Received remote Proxy Host data in ID Payload:
Address 192.168.191.129, Protocol 0, Port 0
26024 06/29/2006 09:03:19.790 SEV=5 IKE/34 RPT=3183 152.111.124.186
Group [3rdParty] User [Matador1]
Received local IP Proxy Subnet data in ID Payload:
Address 0.0.0.0, Mask 0.0.0.0, Protocol 0, Port 0
26027 06/29/2006 09:03:19.790 SEV=5 IKE/66 RPT=3166 152.111.124.186
Group [3rdParty] User [Matador1]
IKE Remote Peer configured for SA: ESP-3DES-MD5
26028 06/29/2006 09:03:19.800 SEV=4 IP/6 RPT=9
Unable to add static route to 192.168.191.129.
26029 06/29/2006 09:03:19.920 SEV=4 IKE/49 RPT=4336 152.111.124.186
Group [3rdParty] User [Matador1]
Security negotiation complete for User (Matador1)
Responder, Inbound SPI = 0x75e81b7e, Outbound SPI = 0xd54fdca5
26032 06/29/2006 09:03:19.930 SEV=4 IKE/120 RPT=4336 152.111.124.186
Group [3rdParty] User [Matador1]
PHASE 2 COMPLETED (msgid=689ff330)
26033 06/29/2006 09:03:19.930 SEV=4 NAC/27 RPT=769
NAC is disabled for peer - PUB_IP:152.111.124.186,
PRV_IP:192.168.191.129
26034 06/29/2006 09:04:21.990 SEV=5 IKE/50 RPT=1618 152.111.124.186
Group [3rdParty] User [Matador1]
Connection terminated for peer Matador1.
Reason: Peer Terminate
Remote Proxy 192.168.191.129, Local Proxy 0.0.0.0
26037 06/29/2006 09:04:21.990 SEV=5 IKE/194 RPT=850 152.111.124.186
Group [3rdParty] User [Matador1]
Sending IKE Delete With Reason message: No Reason Provided.
26039 06/29/2006 09:04:22.000 SEV=4 AUTH/28 RPT=843 152.111.124.186
User [Matador1] Group [3rdParty] disconnected:
Session Type: IPSec
Duration: 0:01:02
Bytes xmt: 0
Bytes rcv: 0
Reason: User Requested
26042 06/29/2006 09:04:22.000 SEV=4 IPDBG/5 RPT=9
Unable to delete static route to 192.168.191.129.
|
| Similar Threads | Posted | | VPN 3005 Error updating group for LAN-to-LAN connection (Too Many Entries Error. Delete an entry before adding a new one). | August 25, 2006, 2:25 am |
| Cisco VPN 3005 error | June 5, 2008, 2:49 pm |
| What is the default precedence: local-route, static-route, OSPF-route? | August 4, 2008, 3:00 am |
| 3005 Concentrator Static IP | August 25, 2004, 1:13 pm |
| Need to route SMTP traffic through static interface (not default route) | March 27, 2007, 5:19 pm |
| Can netwrok run static route and dynamic route the same time? | December 1, 2005, 1:18 pm |
| Unable to delete STATIC NAT on a Cisco 3700 router | April 17, 2007, 7:19 am |
| unable route traffice form one interface to other within same router ????? | January 25, 2006, 8:23 am |
| how to set a Static route in an 837 | March 7, 2005, 8:38 pm |
| static route | October 3, 2005, 6:15 am |
|
|
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map