|
Posted by Scot on November 15, 2004, 11:37 am
If you were Registered and logged in, you could reply and use other advanced thread options
I have a 2621 that uses a T1 currently as my main internet connection.
Ethernet0 is going towards internal home-side. I want to plug a cable modem
with a static address into Ethernet1.
At that point I want to set up the config to route all traffic from my
internal home-side to go out the T1 unless it is http, for example, which I
would preferably want to send out the cable modem. Then if the T1 is down,
send everything out the cable modem. And/or if the cable modem is down make
sure the things like http that are priority routed out the cable modem,
failover to the T1.
Anyone have any suggestions, or better yet, point me to some cisco docs with
examples of a similar setup? I have been searching through their docs, but
so far no luck.
Thanks in advance,
Scott
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML site map